Keysight N6141EM0E EMI Measurement Application
Key Features:
- Provides built-in CISPR and MIL-STD compliant bandwidths, detectors and band presets and automated testing to regulatory Limit Lines with user-selected margins
- Support amplitude correction for antennas, LISNs, cables, preamps
- Provides built-in report generation
- Perform precompliance radiated and conducted emissions measurements and diagnose non-compliant emissions with extensive spectrum analysis capability; Further you can analyze emissions vs. time using Strip Chart functionality
- Performance:
- Display log frequency span and three simultaneous detectors
- Reduce measurement time with built-in signal list and Monitor Spectrum capabilities
- Speed data collection with optional Time Domain Scan capability
- Support multi-touch user interface and SCPI remote interface programming
- KeysightCare software support subscription included
Documents and Software Solutions:
To avoid costly delays that can result from failed compliance testing, Keysight’s EMI measurement application on X-Series signal analyzers allows you to perform precompliance measurements and diagnostic evaluation of your designs. Find and fix problems before they enter the test chamber with the N6141EM0E measurement application.
The application’s wide range of features enables you to: – Use the scan table to set up frequency ranges, gains, bandwidths, and dwell time – Scan a frequency range and display the results in log or linear format – Identify suspect signals in the frequency scan – Measure the peak, quasi-peak, EMI-average or RMS-average values of these suspect signals and place the results in the signal list – Easily identify signals that fail the regulatory agency limit
EMI precompliance measurements Performing precompliance radiated and conducted emissions measurements early in the design cycle can reduce development expense by ensuring new designs will pass final compliance testing at an accredited facility, avoiding costly redesign and re-testing. For a step-by-step guide on how to make precompliance measurements according to regulatory agency limits, refer to the application note, Making Conducted and Radiated Emissions Measurements, literature number 5990-6152EN.
To avoid costly delays that can result from failed compliance testing, Keysight’s EMI measurement application on X-Series signal analyzers allows you to perform precompliance measurements and diagnostic evaluation of your designs. Find and fix problems before they enter the test chamber with the N6141EM0E measurement application.
The application’s wide range of features enables you to: – Use the scan table to set up frequency ranges, gains, bandwidths, and dwell time – Scan a frequency range and display the results in log or linear format – Identify suspect signals in the frequency scan – Measure the peak, quasi-peak, EMI-average or RMS-average values of these suspect signals and place the results in the signal list – Easily identify signals that fail the regulatory agency limit
EMI precompliance measurements Performing precompliance radiated and conducted emissions measurements early in the design cycle can reduce development expense by ensuring new designs will pass final compliance testing at an accredited facility, avoiding costly redesign and re-testing. For a step-by-step guide on how to make precompliance measurements according to regulatory agency limits, refer to the application note, Making Conducted and Radiated Emissions Measurements, literature number 5990-6152EN.